MATERIAL
--------
1 power suupply (5V @ 2 A)
1 VME crate 6U with:
        1 Control-X board
        1 Patgen board
        1 ROS-8 board
1 cable ROBUS with 3 ODU connectors
External Termination of the ROBUS
Power cable
4 signal cables
3 twisted pair cables
1 pair to Ethernet RJ45 cable



Twisted pairs:
One of them goes from Control-X PLS0 output to Patgen lower pins input. Positive always on the right.
One of them goes from any of the Control-X CLKn outputs to the clock connector on the ROB J11 (polarity important depending on ROBUS lenght:

cpujtag interference)
One of them goes from any of the Control-X CLKn outputs to the clock connector on the ROS J22 upper (polarity not important)



Set in the ROB one addres with switch S1. Leave swithc 4 UP (not like in the Minicrate).
Better if you put all switch to 0

OPEN C:\CMS_cris\TEST_prod_ROB128_v2\TEST_prod_ROB128
and execute ROB TEST.llb
Select "t_ROB TEST.vi"

Run it.
you will need to adjust the timing depending on the signal cable´s length.